Washing machine, dishwasher and dryer parts

A guide to the main parts of home appliances: what each part does, how its failure shows, how it is checked and when it needs repair or replacement.

Washing machine · 12 Dishwasher · 6

Washing machine: main parts

A washing machine is built from a few main assemblies. The inlet valve fills the tub and the pressure switch (water level sensor) watches the level. The heating element heats the water and an NTC sensor measures its temperature. The motor turns the drum: brushed motors have a drive belt and carbon brushes, while inverter and direct-drive motors have no brushes. The drum turns on bearings, and springs and shock absorbers damp the shaking during the spin. After the wash the drain pump pumps the water out, and the door lock keeps the door shut while there is water in the tub. The control board (module) runs all of it.

Drain pump It pumps the water out of the tub, and when it fails the machine will not drain and shows a drain error Heating element It heats the water to the selected temperature, and when it fails the machine washes in cold water or trips the RCD Motor and carbon brushes It turns the drum during washing and spinning, and when it fails the drum stands still or will not speed up Drum bearings and seal They carry the drum shaft, and when they wear the machine roars on the spin and the drum has play Shock absorbers and tub springs They damp the swinging of the tub on the spin, and when worn the machine bangs, shakes and walks across the floor Door lock (interlock) It locks the door during the wash, and when it fails the machine will not start or the door will not open Pressure switch (water level sensor) It tells the board how much water is in the tub, and when it fails the machine will not fill, overfills or will not spin Control board (electronic module) It runs every part by the programme, and when it fails the machine will not switch on, freezes or acts oddly Water inlet valve It lets mains water in, and when it fails the machine will not fill or keeps filling Door seal (door boot) The rubber boot that seals the door; dirt, mould or a hole cause smells and leaks at the front Temperature sensor (NTC thermistor) It tells the control board how warm the water is, and when it fails the machine washes cold or shows a sensor error Drive belt It carries the turn from the motor to the drum, and when it comes off or snaps the motor runs but the drum stays still

→ Washing machine repair → Problems → Washing machine error codes

Dishwasher: main parts

A dishwasher works with a small amount of water and circulates it again and again. The inlet valve (with Aquastop protection on many models) fills the sump at the bottom, and the softener with salt lowers the water hardness. The circulation pump takes the water from the sump and sends it under pressure to the spray arms, which spray it over the dishes; the water runs back, passes through the filters and enters the pump again. A heater warms the water — on many Bosch and Siemens models it is built into the pump (a "heat pump"). After each stage the drain pump pumps the dirty water out. The control board runs it all, and a leak sensor in the base stops the machine if water gets into the base tray.

→ Dishwasher repair → Problems → Dishwasher error codes

Not sure which part has failed? A MasService technician comes to your home in Baku, diagnoses the appliance and names the price before starting the repair.

Call now WhatsApp