Washing machine temperature sensor (NTC): signs of failure, testing and replacement

The temperature sensor (NTC thermistor) is a small part fitted next to the heating element at the bottom of the tub. It tells the control board how warm the water is. Its electrical resistance changes with temperature: the warmer the water, the lower the resistance. The board reads the temperature from that resistance.

The sensor does not heat the water itself, but without it the board does not know when to switch the heater on and off. If the reading is missing, out of range or stops changing, the machine either does not heat the water or stops the programme and shows a temperature sensor error. That is why, when a machine "washes cold", a technician checks not only the heater but also the sensor and its wiring.

Call now

Signs of failure

  • the machine washes in cold water although a 40 or 60 °C programme is selected, while cold programmes run normally;
  • a temperature sensor error on the display: tE on LG and Samsung, F22 on Bosch and Siemens, F03 on Indesit and Ariston, E71 on Electrolux, AEG and Zanussi, F1 on Gorenje, F1 or F2 on Miele;
  • the programme takes much longer than usual: the machine waits for a temperature it cannot measure;
  • the error appears only on programmes with heating;
  • the error comes and goes — typical of a loose connector or a wire worn through by vibration.

When this part fails: Not heating water · Takes too long

How it is checked

The sensor itself cannot be tested without opening the machine, but there are a few things you can do yourself.

  1. Unplug the machine for a few minutes, then start a heated programme again: a one-off glitch clears after a restart.
  2. Start a 40 or 60 °C programme and carefully touch the door glass after about half an hour. If it stays cold, the water is not heating — note which code the machine shows.
  3. Make sure the machine is plugged into a sound socket without an extension lead: with a poor contact and voltage drops, heating and sensors work erratically.
  4. Do not remove the back panel or touch any wiring while the machine is plugged in.

What the technician checks:

  • the sensor connector and wiring: a corroded contact or a wire worn by vibration gives the same errors as the sensor itself;
  • the sensor's resistance with a multimeter — if it is open, shorted or does not change as it warms up, the sensor is replaced;
  • the heating element and its circuit: on many models the sensor sits right in the heater and both are tested together;
  • the control board — if the sensor and wiring are fine but the error stays.

Repair and replacement

Replacing the temperature sensor is a quick repair, usually done on site without taking the machine away. On some models the sensor is separate and plugs into a socket next to the heater; on others it is built into the heater, and then the heater is replaced together with the sensor.

Do not keep washing for long with a faulty sensor: clothes do not come out clean and programmes take longer than usual. If the sensor gives wrong readings, the board may keep the heater on longer than it should.

A MasService technician comes to your home anywhere in Baku, checks the sensor, the heater, the wiring and the board, and gives you the price before starting work.

Frequently asked questions

The machine washes cold — is it the heater or the sensor?

It can be either. A burnt-out heater does not heat; with a faulty sensor the board does not get a proper reading and does not switch the heating on. A technician measures both parts.

Can I still wash if the machine shows a temperature sensor error?

Programmes without heating usually run, but heated programmes will stop or wash cold. It is better to have the sensor checked straight away.

Why does the error come and go?

Most often it is the sensor connector or wire: vibration during the spin breaks the contact and it comes back again. This shows up when the wiring is inspected.

Could not fix it yourself? A technician comes to your home in Baku, finds the cause on site and names the price before the repair: Washing machine repair

Call now WhatsApp