Washing machine drum not turning: causes and what to check
The machine switches on and the programme runs, but the drum stays still or barely moves. This is not the same as "not spinning": there the drum turns during the wash but does not speed up.
Siemens and Bosch say that sometimes this is normal: on wool programmes and when excess foam is detected the drum moves very little or not at all. If the drum does not turn on a normal programme, the usual causes are the drive belt, the motor's carbon brushes or the motor itself.
Likely causes
- a programme phase: on wool and delicate programmes, or with excess foam, the drum barely moves — this is normal (Siemens, Bosch);
- a new machine with the transport lock still fitted (Bosch);
- low water pressure or a clogged filter in the inlet hose: the machine waits for water and does not start washing (Bosch);
- the drive belt has come off or snapped (Siemens, whitegoodshelp);
- worn motor carbon brushes (Siemens, Bosch, whitegoodshelp);
- a broken wire or poor connection between the board and the motor, a faulty tacho, motor or control board (whitegoodshelp);
- an item stuck between the drum and the tub — a sock, a coin, a bra wire (whitegoodshelp, LG).
Parts that may be to blame: Motor and carbon brushes · Drive belt
Safe steps you can try
- Look at the display: if there is an error code, find its meaning in the manual or in our error code database (LG).
- Check the programme: on wool, hand wash and with a lot of foam the drum is meant to move very little (Siemens, Bosch).
- If the machine is new, check that the transport bolts (transport lock) on the back have been removed (Bosch).
- Check the water: the tap must be fully open. Bosch suggests holding a bucket under the tap — about 10 litres should come out in a minute. If the pressure is fine, switch the machine off, close the tap and clean the mesh filter in the inlet hose.
- Unplug the machine, open the door and turn the drum by hand (Siemens, whitegoodshelp):
- it turns too easily — the belt has most likely come off or snapped;
- it turns as usual — the problem is more likely the motor, brushes or electrics;
- it is stiff or catches — an item may be stuck, the belt tangled or a bearing seized.
- If you hear something rolling or rubbing inside, do not start another wash — a trapped item can damage the tub.
When to call a technician
Call a technician if the drum does not turn on a normal programme while water supply and programme are fine. Siemens and Bosch state that belt and carbon brush repairs need a trained engineer: the machine has to be opened and the brushes and motor are tested with a meter. Whitegoodshelp reminds you to unplug the machine before any work inside it.
A MasService technician checks the belt, brushes, motor, wiring and board and tells you the price before the repair starts.
Error codes for this fault
Frequently asked questions
The drum does not turn on the wool programme — is it broken?
No. Siemens and Bosch say that on wool programmes and when excess foam is detected the drum moves very little or stops — that is normal operation.
How can I tell the belt has snapped?
Unplug the machine, open the door and turn the drum by hand. If it turns with almost no resistance, the belt has most likely come off or snapped (Siemens).
The drum does not turn but the motor hums — what is it?
It can be a trapped item, a seized bearing, or a motor or board fault. Do not run the machine again and call a technician: the motor and board are tested with a meter.
Other faults
Washing machine repair — Brands
Could not fix it yourself? A technician comes to your home in Baku, finds the cause on site and names the price before the repair: Washing machine repair