Washing machine stops mid-cycle: causes and what to check
The machine filled, turned the drum and then stopped — with an error code or without one. Manufacturers name similar causes: Electrolux — an imbalanced load and problems with the water supply or the drain; Bosch — filling and draining, heating and a detected leak; LG — an unbalanced load during the spin and a pause that lasted too long.
If the display shows a code, look up its meaning in our error code database first: it narrows the search at once.
Likely causes
- an unbalanced load: the laundry has bunched up, and the machine stops to avoid damage during the spin (Electrolux, LG);
- an overloaded drum — the laundry then shifts to one side more often (Electrolux);
- no water or low pressure: the tap is not fully open, or the inlet hose is kinked or blocked (Electrolux, Bosch);
- the machine cannot drain: the drain pump is blocked or the drain hose is kinked (Electrolux, Bosch);
- the machine was paused and not resumed — after a while it turns itself off (LG);
- a problem heating the water — usually with an error code (Bosch);
- a leak was detected — the machine stops as a safety precaution (Bosch).
Safe steps you can try
- Look at the display: if there is an error code, find its meaning in the manual or in our code database (LG).
- If the machine stopped during the spin, open the door and spread the laundry evenly around the drum. Do not overload the drum (Electrolux, LG).
- Check the water supply: the tap fully open, the inlet hose not kinked or blocked (Electrolux, Bosch).
- Check the drain: the drain hose must not be kinked. Unplug the machine and clean the drain pump filter with a container underneath — water will run out (Electrolux, Bosch).
- If the machine was paused, switch it on and start the programme again (LG).
- Reset it: switch the machine off, unplug it for a few minutes, then switch it on again (Electrolux, LG).
- If there is water under the machine, do not run it again and do not try to repair it yourself — Bosch advises calling an engineer.
When to call a technician
Call a technician if the machine stops again after these checks, shows the same error code, does not heat the water, or water appears underneath. The cause may be the drain pump, the inlet valve, the heater, the water level sensor, the door lock or the control board.
A MasService technician will check the machine on site and name the price before starting the repair.
Error codes for this fault
Frequently asked questions
Why does my washing machine stop during the spin?
Most often because of an unbalanced load: the laundry has shifted to one side, and the machine stops the spin to avoid damage. LG and Electrolux advise spreading the laundry evenly and not overloading the drum.
The machine stopped without an error code — what should I check?
Electrolux names three common causes: an imbalanced load, the water supply (tap, pressure, inlet hose) and the drain (a blocked pump). A reset also helps: unplug the machine for a few minutes.
Can I keep washing if there is water under the machine?
No. Bosch says the machine stops as a safety precaution when a leak is detected, and advises against repairing it yourself if the cause is not found.
Other faults
Washing machine repair — Brands
Could not fix it yourself? A technician comes to your home in Baku, finds the cause on site and names the price before the repair: Washing machine repair