E06 Siemens dryer error E06 — heating fault

Medium severity

What it means

If your Siemens dryer shows E06: the dryer cannot heat the air or there is a fault in the heating circuit.

Likely causes

Burnt-out heating element, open thermostat or thermal fuse, clogged lint filter or exhaust.

Safe steps you can try

Clean the lint filter and exhaust, unplug for 10 minutes and plug back in.

Dryer heating and sensors: step-by-step check

  1. Unplug the dryer for 10–15 minutes: if the overheat protection has tripped, it needs to cool down.
  2. Clean the lint filter in the door opening — it should be cleaned after every load.
  3. On a condenser dryer rinse the heat exchanger behind the lower flap; on a heat-pump model clean the lower filter.
  4. Empty the condensed-water container.
  5. Wipe the metal strips of the moisture sensor inside the drum with a soft cloth: fabric-softener film stops them sensing moisture.
  6. Do not overload the drum, and check that the room is not hot and has fresh air. Start the programme again.

When to call a technician

If it persists, the heater, thermostats and thermal fuse must be tested with a multimeter.

What a technician will check

A technician checks the temperature sensors, the heater and thermal cut-out, on heat-pump models the compressor and circuit, and the control board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error E06 on a Siemens?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while E06 is showing?

Better not: the laundry stays damp, and overheating can damage both the clothes and the dryer.

The dryer runs but the laundry is still wet — why?

Usually the air cannot flow: the lint filter or heat exchanger is clogged. If cleaning changes nothing, the heater or heat pump is checked.

Couldn't fix it yourself? A technician can come to your home in Baku: Siemens — Dryer repair

Call now WhatsApp