E02 Siemens dryer error E02 — lint filter blocked

Low severity

This code also exists on other appliances: Siemens E02 — Dishwasher error codes

What it means

If your Siemens dryer shows E02: the machine reports that the lint (fluff) filter is clogged or not fitted properly, or the heat exchanger is dirty — air cannot circulate properly.

Likely causes

Lint and fabric-softener residue on the filter, a dirty second (sponge) filter or condenser, the filter not pushed fully home.

Safe steps you can try

Switch off. Take out the lint filter in the door opening and remove the fluff; if it has softener residue, wash it in warm water and let it dry. On condenser and heat-pump models also clean the second filter at the bottom and the condenser as described in the manual. Push the filter fully home. Clean the lint filter after every load.

Filter and airflow: step-by-step check

  1. Take out the lint filter and remove the lint by hand. Once a month wash the mesh under the tap: fabric-softener film blocks it.
  2. Put the dry filter back all the way in: many models will not start without it.
  3. Clean lint out of the filter housing and off the door seal.
  4. On a condenser dryer rinse the heat exchanger; on a vented model check that the vent hose is not crushed or blocked.
  5. Leave free space around the dryer and do not cover the air grille.

When to call a technician

If the error stays after cleaning, the filter sensor, air duct or condenser should be checked.

What a technician will check

If the code stays after cleaning, a technician checks the fan, the air ducts, the temperature sensors and the control board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error E02 on a Siemens?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while E02 is showing?

No. With a clogged filter the dryer overheats and takes several times longer to dry.

How often should a dryer filter be cleaned?

Remove the lint after every load, wash the mesh under the tap about once a month, and clean the heat exchanger as the manual for your model says, usually every one to three months.

Couldn't fix it yourself? A technician can come to your home in Baku: Siemens — Dryer repair

Call now WhatsApp