F13 Hisense washing machine F13 error: door lock fault
Medium severity
What it means
F13 on a Hisense washing machine is a door locking fault: the door is closed, but the machine cannot lock it. Until the lock closes the machine does not fill, so F13 usually appears in the first minutes after starting, before any water comes in — less often at the end of the cycle, when the door should unlock.
F13 is shown by Hisense models with two-digit F codes (F01, F03, F13…) — the machines with a remaining-time display. Older models with one-digit codes (E1, E2…) use a different list.
Likely causes
- the door is not fully closed: laundry or the edge of the door seal is caught;
- the door sags on its hinges and the lock tongue misses the lock;
- a damaged lock guide or a worn door seal;
- a faulty door lock (interlock);
- a broken wire or poor contact in the lock wiring;
- less often, the control module.
Safe steps you can try
- Open the door and check that no laundry or seal edge is caught between the door and the cabinet.
- Close the door firmly — push it near the handle until it clicks.
- Press Start/Pause.
- If the error stays, switch the machine off, switch it on again and reselect the programme.
- Look at the door from the side: if it clearly sags or the lock tongue is bent, the cause is the hinges or the tongue itself.
- Never bridge or bypass the door lock — it stops the door from opening during a wash.
When to call a technician
If F13 comes back after these steps, call a technician. The usual culprit is the door lock itself: it is tested with a meter, and a faulty lock is not repaired but replaced with one that fits your Hisense model. The wiring is checked too and, if the lock and wires are fine, the control module.
A MasService technician checks the lock, hinges and wiring and tells you the price before the repair starts.
In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.
Frequently asked questions
Why does F13 appear right after starting?
The machine tries to lock the door before filling. If the lock does not close, it stops and shows F13 in the first minutes — before any water comes in.
Can I wash with an F13 error?
No. Until the door is locked the machine does not fill or start the programme. Never bypass the lock — it keeps the door shut while there is water in the drum.
Does F13 mean the same on every Hisense washer?
On models with two-digit F codes, F13 is described as a door locking fault. Hisense code meanings depend on the model, so check your machine's manual before replacing parts.
Couldn't fix it yourself? A technician can come to your home in Baku: Hisense — Washing machine repair