E32 Hansa washing machine error E32 — temperature sensor

Medium severity

What it means

If your Hansa washing machine shows E32: the temperature sensor (NTC thermistor) gives an implausible reading or its circuit is open.

Likely causes

Faulty sensor, broken wire, corroded connector, sometimes damaged together with the heater.

Safe steps you can try

Unplug for 10 minutes and plug back in. Check whether the error also appears on a cold program.

Water heating: step-by-step check

  1. Unplug the machine for 10–15 minutes and switch it on again: a one-off electronics glitch clears this way.
  2. Run a 40 °C programme with an empty drum. After 15–20 minutes touch the door glass: it should feel warm.
  3. Check the drain hose: if it lies on the floor, water runs out by itself, the machine keeps topping up with cold water and never gets it warm.
  4. Plug the machine straight into a wall socket, without an extension lead or adaptor: the heater draws about 2 kW.
  5. If the breaker or RCD trips when the machine starts, or you feel a tingle from the casing, unplug it at once and do not use it until it is repaired.

When to call a technician

If it persists, the sensor resistance should be measured and the sensor replaced if needed.

What a technician will check

A technician measures the heating element and checks it for a short to earth, then checks the temperature sensor (NTC), the wiring and the heater relay on the board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error E32 on a Hansa?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while E32 is showing?

Better not. Without heat the detergent dissolves poorly and the laundry does not come clean, and a heater shorting to the casing is an electric shock risk.

Why does a heating element fail?

Most often because of limescale: in hard water it coats the element, which overheats and burns out. Voltage surges are a less common cause.

Couldn't fix it yourself? A technician can come to your home in Baku: Hansa — Washing machine repair

Call now WhatsApp