E12 Hansa washing machine error E12 — water leak
High severity
What it means
If your Hansa washing machine shows E12: the leak protection (Aquastop / base-pan sensor) has detected water and shut off the supply.
Likely causes
Leak from an internal hose or joint, damaged door seal or gasket, cracked tub, excess foam, leak at the inlet hose connection.
Safe steps you can try
Turn off the tap and unplug the appliance. Look for water underneath and at the hose connections. Use less detergent.
Leak: step-by-step check
- Close the water tap and unplug the machine. Wipe up the water around it.
- Check the nuts of the inlet hose and the point where the drain hose enters the waste pipe: that is where it leaks most often.
- Check that the pump filter at the bottom is screwed in tight and that the rubber door seal is intact — no cuts and no objects in its folds.
- Pull out and wash the detergent drawer: when it is clogged, water overflows and runs down the front.
- If it is dry outside but the code stays, water has collected in the base tray under the tub, where the leak sensor sits. The tray has to be dried out, and that is a job for a technician.
When to call a technician
If there is a leak, do not use the appliance: the leak must be fixed and the Aquastop system reset.
What a technician will check
A technician finds the leak inside (hoses, pump, door seal, tub seal), dries the base tray and checks the leak sensor and the Aquastop system.
In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.
Frequently asked questions
How do I reset error E12 on a Hansa?
Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.
Can I keep using the appliance while E12 is showing?
No. Water can reach the electrics and flood the floor or the neighbours below. Keep the tap closed.
The floor is dry, but E12 is showing — why?
Water may have run into the base tray under the tub. There is a float sensor there: until the tray dries or is emptied, the error stays.
Couldn't fix it yourself? A technician can come to your home in Baku: Hansa — Washing machine repair