E4 Midea dryer error E4 — humidity sensor

Low severity

This code also exists on other appliances: Midea E4 — Dishwasher error codes

What it means

If your Midea dryer shows E4: the machine is not getting a valid signal from the sensor that measures how damp the laundry is — drying may run far too long or stop too early.

Likely causes

Fabric-softener or lint film on the sensor bars (usually below the lint filter), faulty sensor or wiring.

Safe steps you can try

Switch off. Wipe the two metal sensor bars near or below the lint filter with a damp cloth (with a little vinegar if needed) and let them dry. Use less fabric softener.

Dryer heating and sensors: step-by-step check

  1. Unplug the dryer for 10–15 minutes: if the overheat protection has tripped, it needs to cool down.
  2. Clean the lint filter in the door opening — it should be cleaned after every load.
  3. On a condenser dryer rinse the heat exchanger behind the lower flap; on a heat-pump model clean the lower filter.
  4. Empty the condensed-water container.
  5. Wipe the metal strips of the moisture sensor inside the drum with a soft cloth: fabric-softener film stops them sensing moisture.
  6. Do not overload the drum, and check that the room is not hot and has fresh air. Start the programme again.

When to call a technician

If the error stays after cleaning, the humidity sensor and its wiring need checking.

What a technician will check

A technician checks the temperature sensors, the heater and thermal cut-out, on heat-pump models the compressor and circuit, and the control board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error E4 on a Midea?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while E4 is showing?

Better not: the laundry stays damp, and overheating can damage both the clothes and the dryer.

The dryer runs but the laundry is still wet — why?

Usually the air cannot flow: the lint filter or heat exchanger is clogged. If cleaning changes nothing, the heater or heat pump is checked.

Couldn't fix it yourself? A technician can come to your home in Baku: Midea — Dryer repair

Call now WhatsApp