F01 Indesit dishwasher error F01 — water leak

High severity

This code also exists on other appliances: Indesit F01 — Washing machine error codes

What it means

If your Indesit dishwasher shows F01: the leak protection (Aquastop / base-pan sensor) has detected water and shut off the supply.

Likely causes

Leak from an internal hose or joint, damaged door seal or gasket, cracked tub, excess foam, leak at the inlet hose connection.

Safe steps you can try

Turn off the tap and unplug the appliance. Look for water underneath and at the hose connections. Use less detergent.

Leak and overfilling: step-by-step check

  1. Close the water tap and unplug the dishwasher.
  2. Think back to what you put in: ordinary washing-up liquid makes a great deal of foam, which runs into the base tray and trips the protection.
  3. Wipe the door seal and check that no dishes stop the door from closing tightly.
  4. Check the inlet and drain hose connections behind the dishwasher and under the sink.
  5. If there is water in the base tray under the tub, the code will not go until it is removed: a float sensor sits there. Tilting a built-in dishwasher yourself is risky — leave it to a technician.

When to call a technician

If there is a leak, do not use the appliance: the leak must be fixed and the Aquastop system reset.

What a technician will check

A technician finds the leak (hoses, pump, seals, sump), dries the base tray and checks the float sensor and the Aquastop system.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error F01 on a Indesit?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while F01 is showing?

No. While the leak protection is active, the dishwasher only pumps out and does not wash. Keep the tap closed.

Why does the pump hum all the time with error F01?

The leak protection has tripped: as long as there is water in the base tray, the dishwasher keeps pumping and will not start a programme.

Couldn't fix it yourself? A technician can come to your home in Baku: Indesit — Dishwasher repair

Call now WhatsApp