F04 Hotpoint dishwasher error F04 — temperature sensor

Medium severity

What it means

If your Hotpoint dishwasher shows F04: the temperature sensor (NTC) gives an implausible reading or its circuit is open — the dishwasher cannot tell the water temperature.

Likely causes

Faulty sensor, broken wire, corroded connector; sometimes damaged together with the heater or circulation pump.

Safe steps you can try

Unplug the dishwasher for 10 minutes, then plug it back in and restart the program.

Dishwasher water heating: step-by-step check

  1. Unplug the dishwasher for 10–15 minutes and switch it on again.
  2. Take out and wash the filters at the bottom of the tub: with weak water circulation the protection switches the heating off.
  3. Check that the spray arms turn freely and that their holes are not blocked.
  4. Check the salt: in hard water without salt the heater quickly gets coated with limescale.
  5. Run a 60–65 °C programme. If the dishes are cold at the end and the code returns, it needs diagnosing. If the breaker or RCD trips, unplug the dishwasher.

When to call a technician

If it persists, the sensor resistance should be measured and the sensor replaced if needed.

What a technician will check

A technician checks the heater (on many models it is built into the circulation pump), the temperature sensor, the heater relay on the board and the wiring.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error F04 on a Hotpoint?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while F04 is showing?

Better not: grease does not come off in cold water, the dishes do not dry, and a heater shorting to the casing is an electric shock risk.

The dishes come out cold and wet — is that related to error F04?

Yes. Most dishwashers dry with the heat of the last hot rinse: if the water is not heated, the dishes stay wet.

Couldn't fix it yourself? A technician can come to your home in Baku: Hotpoint — Dishwasher repair

Call now WhatsApp