E12 Teka washing machine error E12 — overfill
Medium severity
What it means
If your Teka washing machine shows E12: the water level is higher than allowed and the overflow protection has tripped.
Likely causes
Inlet valve stuck open, faulty water level sensor (pressure switch) or a blocked sensor tube.
Safe steps you can try
Turn off the tap and switch the appliance off. Switch it on again after a few minutes — it should pump out the extra water itself.
Water level and overfilling: step-by-step check
- Close the water tap and unplug the machine.
- If there is a lot of water in the drum, do not open the door: drain it through the emergency hose or the pump filter at the bottom.
- Open the tap while the machine is unplugged. If water still runs into the drum, the inlet valve is not closing: shut the tap and call a technician.
- Think back to how much detergent you used: heavy foam fools the level sensor. If there is a lot of foam, run a rinse without detergent.
- Switch on and start a short programme. If the code returns, the level sensor or its tube is faulty.
When to call a technician
If it fills again as soon as the tap is opened, the inlet valve or level sensor must be replaced; do not leave it connected.
What a technician will check
A technician checks the water level sensor (pressure switch), its tube and air chamber, the inlet valve and the circuits on the control board.
In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.
Frequently asked questions
How do I reset error E12 on a Teka?
Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.
Can I keep using the appliance while E12 is showing?
No. If it overfills, water can come out through the drawer and the door onto the floor. Keep the tap closed until the cause is found.
Why does the pump run all the time with error E12?
That is the overflow protection: the electronics think there is too much water and run the drain until the level drops or the machine is switched off.
Couldn't fix it yourself? A technician can come to your home in Baku: Teka — Washing machine repair