E31 Electrolux washing machine error E31 — water level sensor

Medium severity

What it means

If your Electrolux washing machine shows E31: the control board is not getting a valid signal from the water level sensor (pressure switch).

Likely causes

Blocked or detached pressure switch tube, faulty sensor, wiring or connector problem.

Safe steps you can try

Unplug the appliance for 10–15 minutes and plug it back in. Clean the drain filter — a blockage can affect level readings.

Water level and overfilling: step-by-step check

  1. Close the water tap and unplug the machine.
  2. If there is a lot of water in the drum, do not open the door: drain it through the emergency hose or the pump filter at the bottom.
  3. Open the tap while the machine is unplugged. If water still runs into the drum, the inlet valve is not closing: shut the tap and call a technician.
  4. Think back to how much detergent you used: heavy foam fools the level sensor. If there is a lot of foam, run a rinse without detergent.
  5. Switch on and start a short programme. If the code returns, the level sensor or its tube is faulty.

When to call a technician

If the error returns, the pressure switch, its tube and wiring need testing.

What a technician will check

A technician checks the water level sensor (pressure switch), its tube and air chamber, the inlet valve and the circuits on the control board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error E31 on a Electrolux?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while E31 is showing?

No. If it overfills, water can come out through the drawer and the door onto the floor. Keep the tap closed until the cause is found.

Why does the pump run all the time with error E31?

That is the overflow protection: the electronics think there is too much water and run the drain until the level drops or the machine is switched off.

Couldn't fix it yourself? A technician can come to your home in Baku: Electrolux — Washing machine repair

Call now WhatsApp