H6 Daewoo washing machine error H6 — heating fault

Medium severity

What it means

If your Daewoo washing machine shows H6: the appliance cannot heat the water to the selected temperature.

Likely causes

Burnt-out heating element, heavy limescale on the element, faulty temperature sensor or wiring, relay on the control board.

Safe steps you can try

Unplug for a few minutes, plug back in and repeat the program. Watch out for low mains voltage.

Water heating: step-by-step check

  1. Unplug the machine for 10–15 minutes and switch it on again: a one-off electronics glitch clears this way.
  2. Run a 40 °C programme with an empty drum. After 15–20 minutes touch the door glass: it should feel warm.
  3. Check the drain hose: if it lies on the floor, water runs out by itself, the machine keeps topping up with cold water and never gets it warm.
  4. Plug the machine straight into a wall socket, without an extension lead or adaptor: the heater draws about 2 kW.
  5. If the breaker or RCD trips when the machine starts, or you feel a tingle from the casing, unplug it at once and do not use it until it is repaired.

When to call a technician

If the error returns, the heating element and temperature sensor must be tested with a multimeter.

What a technician will check

A technician measures the heating element and checks it for a short to earth, then checks the temperature sensor (NTC), the wiring and the heater relay on the board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error H6 on a Daewoo?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while H6 is showing?

Better not. Without heat the detergent dissolves poorly and the laundry does not come clean, and a heater shorting to the casing is an electric shock risk.

Why does a heating element fail?

Most often because of limescale: in hard water it coats the element, which overheats and burns out. Voltage surges are a less common cause.

Couldn't fix it yourself? A technician can come to your home in Baku: Daewoo — Washing machine repair

Call now WhatsApp