H3 Beko washing machine error H3 — heater relay fault

High severity

What it means

If your Beko washing machine shows H3: the control board has detected a fault in the heating circuit (heater relay).

Likely causes

Shorted heating element or earth leakage, stuck relay on the board, moisture.

Safe steps you can try

Unplug the appliance. If it trips the breaker, do not switch it on again until the heater is checked.

Water heating: step-by-step check

  1. Unplug the machine for 10–15 minutes and switch it on again: a one-off electronics glitch clears this way.
  2. Run a 40 °C programme with an empty drum. After 15–20 minutes touch the door glass: it should feel warm.
  3. Check the drain hose: if it lies on the floor, water runs out by itself, the machine keeps topping up with cold water and never gets it warm.
  4. Plug the machine straight into a wall socket, without an extension lead or adaptor: the heater draws about 2 kW.
  5. If the breaker or RCD trips when the machine starts, or you feel a tingle from the casing, unplug it at once and do not use it until it is repaired.

When to call a technician

This is an electrical safety fault — the heating element and control board should be checked by a technician.

What a technician will check

A technician measures the heating element and checks it for a short to earth, then checks the temperature sensor (NTC), the wiring and the heater relay on the board.

In Baku? A technician comes to your home within 60 minutes and gives the price after diagnostics, before the repair. 6-month warranty.

Call now · +994 50 566 53 58 Message on WhatsApp

Frequently asked questions

How do I reset error H3 on a Beko?

Switch the appliance off, unplug it for 10–15 minutes and switch it on again. If the cause is still there, the code comes back: a reset clears the message from memory, it does not repair the fault.

Can I keep using the appliance while H3 is showing?

Better not. Without heat the detergent dissolves poorly and the laundry does not come clean, and a heater shorting to the casing is an electric shock risk.

Why does a heating element fail?

Most often because of limescale: in hard water it coats the element, which overheats and burns out. Voltage surges are a less common cause.

Couldn't fix it yourself? A technician can come to your home in Baku: Beko — Washing machine repair

Call now WhatsApp